RBT Slides, mounting images with adhesive tabs

[P3D <JGoldenRRP@xxxxxxx>]

Mike Province asked:
>>According to your literature the "Wes" tabs can be ordered >>from Reel 3-D
for easy alignment of slides that might be a >>little off kilter--such as
shoot and shuffle slides. At least I >thought I read it in your RBT flyer.

Mike....good point and I have had many people ask about this product, so I
must not be clear in my info....the product is  from Reel 3-D , catalog
number 8020 Adhesive securing tabs, you get two dispensers each with 1000
tabs in them.

My flyer states this about using these tabs with RBT mounts:

Horizontal and rotational problems....UNDER CONTROL!  Using the simple to
use, sliding track system inside the mount, your film chips are locked, by
the films sprocket holes, into a calibrated position, thus vertical and
rotational problems are eliminated, precise horizontal, vertical, and
rotational alignment every time!   You CAN adjust for rotation if you need
to.  If you shot a "cha-cha" (as Paul Wing calls it) free-hand with a
non-stereo SLR, by shooting-shifting-and shooting, you may wind up with
vertical, horizontal, and rotational imperfections.  When mounting you may
have to "float" the stereo image, by removing the calibrated slide bars (open
up your sample & see attached instructions)  * Try adhesive tabs (from Reel
3-D, see notes below), instead of the slide bars, and get those cha-chas
mounted well.

For more information contact me...thanks Jon Golden


------------------------------