Re: PHOTO-3D digest 2158

[P3D <Cghon@xxxxxxx>]

In a message dated 97-06-29 23:09:13 EDT, you write:

> From: P3D Julius and June Martin <julius-junem@xxxxxxxxxx>
>  >Subject: Print Trimming and Adhesive
>  

Yes, I use Robert Thorpe's system of aligning prints, skewed or 
otherwise, and have found it quite successful.  As to adhesive,
I have an old, but still workable,  Seal Dry Mount press, plus a
new tacking iron.  I cut and trim the prints after lightly tacking
pieces of colormount tissue to the backs, then line  them up
and center them on pieces of matte board, 3 1/2 x 7, and after
checking correct positions for right and left, again lightly tack 2
corners of each. If you must reposition them, it's an easy matter
to pull off the tacked areas.  Pre-heat the press, using the low 
setting, and about 15-20 seconds should give a permanent bond
 -- and don't forget to protect the print surface with several sheets
of Kraft paper!

Carole  


------------------------------