P3D Labels

["ron labbe" <ron@xxxxxxxxxxxx>]

George Gioumousis wrote:

>>>>I've used Avery 5267 labels on my 35 mm slides. No problems, but six
months is hardly archival. The labels do take projection quite well.
I used the label option in Word Perfect, which seemed easier to use
than the corresponding option in my daughter's Microsoft Word.

Unfortunately, 0.5" by 1.75" just won't fit the Realist format. Quite
likely Avery has another label of just the right size.

My major objection is that I need to do 80 at a time, so I run a few
address labels to fill the sheet. <<<

Actually, I've found it easy to just print a portion of the page, later if
you want to print another partial page just set up labels to print in the
areas where there are still labels left.


ron


ron labbe/studio3D
30 glendale st maynard, ma 01754
978 897-4221 fon/fax
mailto:ron@xxxxxxxxxxxx
http://www.studio3d.com


------------------------------