P3D digital VM

["ron labbe" <ron@xxxxxxxxxxxx>]

Peter Davis writes:
>If you could break down the pattern into units which correspond to the film
recorders advance, then it might be as simple as making a single image
which contains 4 VM frames or whatever.

It turns out that you can put digitally put VM slide pairs next to each
other on the top and bottom (2 pairs) of a single 35mm slide. You can then
output multiple pin-registered copies of the image and have every other pair
line up perfectly on the film cutter. (This is done for multiple copies of
each pair.)However, determining exact image size, placement and getting 1:1
registered output is fairly tricky! A high-quality pin-registered film
recorder is a must.



ron


ron labbe

studio3D
30 glendale st maynard, ma 01754
978 897-4221 fon/fax

mailto:ron@xxxxxxxxxxxx
http://studio3d.com


------------------------------