P3D Lab issues

[Bob_Maxey@xxxxxxxx]

>>This reminds me of an incident I had awhile back. I took a roll of E-6
>>to the local lab to be developed only and not cut. A few hour later I
>>got a call, and they told me that the film turned out totally clear. I
>>asked if it was the just the frames or was the entire film clear. They
>>said it was the entire film and that maybe I had a light leak.


If there are no frame lines, just clear edge to edge, it is most likely a lab
problem. A light leak would not cause this because of the way 35mm canisters are
made, the fact that the roll is tightly wound and light can't get to all
surfaces. Another clue might be lack of frame numbers and ID marks. If this is
clear, it's a lab screw up.

RM