[photo-3d] RBT Pin Bars

["David W. Kesner" <drdave@xxxxxxxxxx>]

I am now home and have all the proper paperwork.

Dr. T. was right about the "standard" 0.05mm white pin bars - 
they give you 0.0 to 0.4 in 0.1 offsets.

Now if you use the "new" 0.1mm and 0.2mm grey pin bars along 
with the standard you will be able to have offsets from 0.0 to 
0.7 in 0.05 increments (with the exception of 0.65) if you use 
both top and bottom channels and 0.0 to 0.4 in 0.05 increments 
if you use only the top channel.

I tried to scan the spreadsheet, but it was too small (too 
many cells) to come out clearly. It is actually a double sheet 
as it gives both positive and negative offsets. For example a 
0.2 up in the left and a 0.2 down in the right will give a -
0.4 whereas a 0.2 down in th left and a 0.2 up in th right 
will give a +0.4.

If anyone feels the need I might be talked into typing this in 
a table and putting in the files section.


That's all for now,

David W. Kesner
Boise, Idaho, USA
drdave@xxxxxxxxxx