RE: Filter Behind the Mirror - Revisited

[Clive Warren <Clive.Warren@xxxxxxxxxxxxx>]

At 11:43 pm +0000 26/2/98, Willem-Jan Markerink wrote:

Snippety snippletson

>The only critical specification/size for this project is the height
>of your film rails....you need a marking gauge (vernier callipers)
>to measure this accurately. In my EOS-1 the rails were 0.5mm tall,
>so the filter of 0.4mm plus tape worked fine, no touching or rubbing
>whatsoever.
>
>Are there any other Olympus 2 users on this list, with a marking gauge
>handy? (you need the bottom end of the device, that little pin
>sticking out)

Yes, and there is a good set of vernier calipers sitting in my toolbox -
unless that was the one the burglars took recently, will have to check.
Have been meaning to do this measurement for some time anyway.

Watch this space and remind me if I haven't posted the measurement by the
beginning of next week.




All the best,

              Clive   http://clive.bel-epa.com


*
****
*******
******************************************************
*  To remove yourself from this list, send:          *
*         UNSUBSCRIBE INFRARED                       *
*       to                                           *
*         MAJORDOMO@xxxxx                            *
*----------------------------------------------------*
*   For the IR-FAQ, IR-Gallery and heaps of links:   *
*  http://www.a1.nl/phomepag/markerink/mainpage.htm  *
******************************************************

------------------------------