[MF 3D] Welcome to new MF3D list (was Re: test message)

[Paul Talbot <ptww@xxxxxxxxx>]

Joel Alpers wrote:
 
> This very well may not go through; the old rkymtmem account
> has been deleted. Just checking....

And I had written the other day:

> The mailing list software I have available does permit
> configuration for replies to go to the list, but with
> one limitation: if you have a "reply-to" setting in
> your mail software, the list processor will leave that
> setting *intact* and will NOT override it with the list
> address.  (It is generally only necessary to have a
> "reply-to" setting if you have replies sent to an
> address different from your posting address.)
> 
> If this is an acceptable situation to everyone here,
> I can go ahead and activate the new list.  If it will
> be a problem, then I'll go with the backup plan, which
> is to have the list set up by Bill Costa at UNH.

I'll take the silence as lack of objection.  ;-)  So let's
see if this will work out.

If you were subscribed to the old list you should get TWO
copies of this message, one from frii and one from rmm3d
(assuming the plug has not quite yet been pulled on the
old list).

If you only receive this message from frii, let me know
(off-list) so I can add you to the new list.  If you only
receive this message from rmm3d, it means I know that you
unsucessfully tried to get on the old list, and I have
already added you to the new list.

I don't know yet how well digests are going to work.  We
shall see.

Please make note of the new address for list submissions:
MF3D.Forum@xxxxxxxxx

Subscribe/unsubscribe requests go to:
MF3D.Forum-request@xxxxxxxxx

OK, holding my breath and crossing my fingers now... ;-)

Paul Talbot