Whoops

[LDAEnt@xxxxxxx]

My ASCI drawing of the light box circuit isn't correct.  It shows the brass
strip as continuous underneath the batteries.  The brass strip must of course
be cut and separated at this point to allow the batteries to be in the
circuit.
The brass strip approach is cheaper, but much harder to accurately make, as
it must hold the batteries in contact and have a gap between the bulb and the
brass strip.  If you can find all of the separate parts (switch, bulb base,
battery holders) then I would recommend this approach, it's guaranteed to
work and will give you more room in the box to put in the reflectors. 


------------------------------