Mailinglist Archives:
Infrared
Panorama
Photo-3D
Tech-3D
Sell-3D
MF3D

Notice
This mailinglist archive is frozen since May 2001, i.e. it will stay online but will not be updated.
<-- Date Index --> <-- Thread Index --> [Author Index]

Cutting mirrors

  • From: P3D <HPOSTER@xxxxxxxxxx>
  • Subject: Cutting mirrors
  • Date: Tue, 21 May 1996 18:53:33 -0500 (EST)
Elliot asks about....
>>Does anyone out there have any 
>>suggestions for cutting front surface 
>>mirrors? I used to think I was a pretty 
>>good glass cutter until I tried
 >>to deal with this stuff!

   In the past, on very small cuts, I've been pretty successful with scoring
the surface (or actually cutting through) with a "Dremel" type tool. 

        Good luck!                                  Harry Poster


------------------------------