re: VRex crashing

[P3D Ralph Johnston <copley@xxxxxxxxxxxx>]

I just downloaded the patch from the VRex web page and ran it.  Then I went
into the DOS basic mode and ran the "Test VR Surfer" part as instructed.
This gave the message "EMM386 has halted your program with error #01 at
address FDC0:0049.  Please hit enter to restart your computer.  (It didn't
restart)

Now its time to get on the phone with VRex.

I have a Tseng ET4000 2M video card that came with my Gateway 4DX2-50V
computer (now 3 years old).  Maybe this is the problem in that they don't
support my video board.


At 10:57 PM 11/12/96 -0500, you wrote:
>Hi Ralph,
> Did you contact VRex about the crashing through their web page?  What did
>they say?
>Best,
>Bob
>--
>Bob Stern
>rstern@xxxxxxxxxxxx
>
>
>
*****************************************************************
*   Linda Sherman/Ralph Johnston
*   LINMAR PERSIANS
*   Solids, Bicolors, & Tabbys
*   E-MAIL copley@xxxxxxxxxxxxxxxxxxx
*   WEB PAGES http://www.ultranet.com/~copley/
*   35 Groveland St.
*   Newton, MA 02166
*   617-527-7562
*****************************************************************


------------------------------