Brackett slide-holder works upside down too...

[P3D Dr. George A. Themelis <fj834@xxxxxxxxxxxxxxxxxxxxx>]

>> >Hold it upside-down!  You'll have it pressed against your forhead,

>But if you do that, when you get your slides back from Kodak you have
>to hold the viewer upside down to make the image look proper, and
>that will make the slides fall out!!!  Would have to use some duct tape
>to hold the slide in place for each one viewed!  Makes the viewer 
>slide-holder dohicky I bought (made by Mr. Brackett) utterly useless!

Mike, I am sure you can screw the slide-holder upside down...

If any one is interested, I still have a few of those left for sale...
ooops, wrong list!

About projection... just feed the slide the normal way (not upside-
down) as it should have been done in the first place...

>P.S. -  List's been too quiet....

Yeah... I've busy lately... :-)

George


------------------------------

End of PHOTO-3D Digest 2249
***************************
***************************
 Trouble? Send e-mail to 
 wier@xxxxxxxxxxxxxxxxxxxxxxxx 
 To unsubscribe select one of the following,
 place it in the BODY of a message and send it to:
 listserv@xxxxxxxxxxxxxxxxxxxxxxxx 
   unsubscribe photo-3d
   unsubscribe sell-3d
   unsubscribe overland-trails
   unsubscribe icom
 ***************************