Mailinglist Archives:
Infrared
Panorama
Photo-3D
Tech-3D
Sell-3D
MF3D

Notice
This mailinglist archive is frozen since May 2001, i.e. it will stay online but will not be updated.
<-- Date Index --> <-- Thread Index --> [Author Index]

P3D Cutting Foam


Probably done on an NCR machine. My only tip is to put the foam in the
freezer for a few hours. This will harden the foam and make it easier to
cut. Tape a pattern to the top side of the foam and use a hot wire cutter.
Or you can use a decent knife with a serrated edge. A bread knife works
very well.

RM



------------------------------