P3D Re: iron setting

[CanterMike@xxxxxxx]

In a message dated 98-10-05 16:36:01 EDT, Jeremy writes:

<<  holy iron settings batman!
 
 Sometimes (snip) steam and water come out of
 it!, which is bad.  What setting do you guys use when sealing heat
 seal mounts? >>


I use a Seal tacking iron.  Picture a miniature teflon coated iron on the end
of a soldering iron and you'll be close.  (I refer to it as my Barbie iron.)
It is just exactly wide/narrow enough to fit between the apertures on the
mount.


M


------------------------------