P3D Re: VM mounting with rubber glove?

[Steve Berezin <sbere@xxxxxxxxxxxxx>]

I've started doing this with finger cots, the little rubber thingees
that accountants use to cover their fingers.  Somebody on this list
suggested their use.

They seem to work OK.  However, they still seem to leave prints
sometimes which I can't seem to figure out.

Klaas Morcus wrote:
> 
> Mounting the film chips in View-Master reels was not exactly a joy.
> However I "discovered" that using a rubber glove simplifies mounting
> extremely. No expanding of the pockets is necessary, so less risk of
> getting height or/and rotation errors. Just position the chips with
> thumb and finger. Any objections?
> --
> mailto:k.morcus@xxxxxx

-- 
Steve Berezin
mailto:steve@xxxxxxxxxxx
http://www.berezin.com/3d
Viewers, Slide boxes, 3D books, View Master


------------------------------