P3D Re: Laminator for heat seal slides

[JNorman805@xxxxxxx]

Todd Eifert writes:

<< After all the talk about using a laminator for heat sealing mounts, I
 bought the GBC Docuseal 40 from Staples for $49.  A little expensive,
 but I was in a gotta have mood.  It works great.  No heat adjustment
 and none seems to be needed.  It takes 2 slides at a time a hasn't
 melted 1 chip.  I have tried it with cardboard pouch and without.  Both
 work fine, but it loads a little smoother with the pouch.  I've found
 that occasionally, I have to nudge the slides through when they hit the
 rollers.  The end result is a perfectly sealed slide, much better than
 I could do with the iron. >>

This sounds interesting.  But how do you make sure the chips don't slip in 
the mount as you're sending it through the laminator?

Jim Norman