[photo-3d] Re: Bristol wrenches

[David Glick <xid@xxxxxxx>]

In Message: 10  Digest 36   "Dan Shouse" <wobeck@xxxxxxxx>  said:

>Does anyone know the sizes of the bristol wrenches required to work on the 
>Revere camera. Also, does it require a 4 or 6 point wrench? Thanks.

They are both 4-point.  I have the set of 10 from Jensen, and based on the
sizes they list in their catalog, and measuring and placing the actual keys
in order, the two that I marked when I used them on my Revere are:
0.048 inch 4-spline  for the rangefinder distance wheel and I think the
wind shaft tension, and
0.076 inch 4-spline for the wind and rewind knobs.

I don't have the Revere here right now to check it further.

For the Jensen set, see page 201 of the fall 99 - spring 2000 catalog:
spline key set  79-055   $8.95
It's also on their web site, go to   http://www.jensentools.com/    and
search on spline.

By the way, there is a typo in their description, the largest one in the
set is actually 0.133 not 0.113.

If you loosen a screw on the Revere and the knob is still tight, remove
that screw completely and you'll probably find a second one under it.
I also found Jess Powell's videotape on Revere adjustment and repair to be
very helpful.

Dave Glick

------------------------------------------------------------------------
PERFORM CPR ON YOUR APR!
Get a NextCard Visa, in 30 seconds!  Get rates as low as 
0.0% Intro or 9.9% Fixed APR and no hidden fees.
Apply NOW!
http://click.egroups.com/1/2121/5/_/160438/_/954873754/
------------------------------------------------------------------------