Re: [photo-3d] Spicer mounting, hyper photo posted

[Jim Benbow <blip23@xxxxxxx>]

On Fri, 04 Aug 2000 08:23:09 -0400, the head of Ralph Johnston/Linda Sherman
<copley@xxxxxxxxxxxxxxx> split open and the following poured out:

>Anyway, I just mounted my 8-perf RBT slides in Spicer mounts using the RBT
>jig.  These were in 7 or 8 perf cutouts.  Out of  two rolls, I had three
>pair with vertical misalignment and had to go back and remount them in RBT
>mounts.  

I've been meaning to make an RBT jig with the cut outs on the top on one side
and the bottom of the other for mounting slides with vertical errors greater
than both RBT with pins on the bottom can compensate for. Then tape one chip on
the top and the other on the bottom.

>Then they were fine.  I think I need a more accurate way to align
>the RBT jig with the Spicer mount.  Am I being too sloppy?  Maybe need to
>pinch at each end instead of just in the middle.

There isn't much plastic along the top of a full frame RBT jig. Maybe if you
used the jig upside down it would align better.

Jim Benbow
blip23@xxxxxxx