Re: [photo-3d] Slip-in mounts?

[drdave@xxxxxxxxxx]

Bob Aldridge writes:

> On the contrary, as they were originally designed and produced by 
> the firm of Albion Engineering (the same company as produced the Hawk
> projector), when the owner of the company decided to retire a few 
> years ago one of the members of the Stereoscopic Society who owns an 
> engineering and machining company bought the dies and the rights to 
> the Albion Foils, and they are now in production again.

We were not talking about the Aluminum Albion mask which is currently 
avaialble from many 3d suppliers, but a similar design in cardboard 
where a "U" shaped cut was made above and below each window aperture. 
This allowed the film chip to be slid under and positioned with 
adjustments in all four directions - just like the Albion.

Does anyone know who, what, where, when about these cardboard masks?

Thanks,

David W. Kesner
Boise, Idaho, USA
drdave@xxxxxxxxxx