Re: stiff Sputnik advance

[erker@xxxxxxxxxxxxxx (Greg Erker)]

>On my earlier Spud (one I didn't keep) there were advance problems. Since
>the film was factory packed that wasn't the problem. My call was that it
>was a combination of warpage of the plastic, and the alignment of the
>metal rollers. Look for points of pinching and film contact...

  That's a good point. If the rollers and
spool holders aren't all square relative to
each other, then you will end up with the
film trying to run off the edge of the roll
even if you load it perfectly.

Greg