P3D SIF on NT

[Marvin Jones <Campfire@xxxxxxxxxxxxxx>]

Message text written by INTERNET:photo-3d@xxxxxxxxxxxxxxxxx
>><< Stereo Image Factory also refuses to run under Windows NT4.0, even
> though it successfully installs under same.
>
>Not true.  This has been fixed since version 1.2.  Under NT the page
flipping
>support for the Total3D gets disables as this isn't supported under NT.

All right, let me rephrase:  The version of Stereo Image Factory that is
provided on Dan's 3D-CD refuses to run under Windows NT4.0, even though
it successfully installs under same.<

Out of curiosity, I just tried to install SIF on my NT, using the current
1.35 version downloaded from the site a couple of days ago. (I'm normally
using the program on my 95 with great success and much appreciation.) I had
wondered if the problem was the version of NT, since I had another graphics
program that required me to upgrade to Service Pack 3 because it would not
run under anything less. The reason was that the program used DirectX,
which SIF does, also. SIF does install perfectly on my NT, but it crashes
when I try to run it. The error message is something about not finding an
entry point in some file or another. It's not a problem for me, since my NT
is reserved for non-linear editing, and I use SIF on my 95 normally, but
not everyone is bi-computal like me, I suppose.


------------------------------