[photo-3d] Re: Fuji Frontier Printer

[dinoddd@xxxxxxxxx]

Yes, it's a 2x2 mount that was made for slides taken with the old 
Robot brand cameras. The dimensions of a Robot slide chip appear to 
be the same as a Realist slide chip. I doubt, however, that Pegco 
still makes these mounts.
Another mount that can be used is a half-frame mount such as the Gepe 
glass mount that will take a Realist slide chip without trimming 
needed. You can adjust the chip horizontally for the best composition 
visible in the 18x24mm opening of the mount.




--- In photo-3d@xxxxxxxxxxx, Dave Williams <davidrw@xxxx> wrote:
> dinoddd@xxxx wrote:
> 
> > I just got some prints made from one side of some Realist slides
> > using the Frontier machine.  I unmounted a chip from a heat-sealed
> > cardboard mount then remounted the chip in a Pegco Robot format 
slip-in
> > mount before giving it to the lab
> 
> I'm not familiar with this mount. Is it a 2x2 mount?
> 
> Thanks for the info!
> 
> Dave